Upgraded Dust Collection Boot for DeWALT DW716 & DWS716 Miter Saws
Upgraded Dust Collection Boot for DeWALT DW716 & DWS716 Miter Saws
This silicone dust boot can be added to the DeWALT DW716 or can replace the factory dust boot on the DeWALT DWS716, to collect the majority of the unbearable amount of dust created by these miter saws.
It's made from 2mm thick silicone for the perfect balance between weight, rigidity, and durability, and works at all but the most extreme compound angles. Installs into the dust port and attaches to the metal or plastic bracket behind the blade. Two sets of holes are pre-punched for mounting to the saw using the factory screws from the plastic bracket on DWS716 & DWS716XPS saws, or to an Inspire Woodcraft REPLACEMENT BRACKET.
Can also be installed on the metal bracket of the DW716 & DW716XPS saws with suitable magnets (not included).
A video can be SEEN HERE for further information and installation instructions.
Share
Instructor very knowledgeable.
Have not instlled yet.....
The silicon dust boot is just what my Dewalt Miter Saw needed. Love the saw, hated the dust. My only other options were to cut outside, build a box to surround it or buy one of those tents. The boot from Inspire Woodcraft did the trick.
it catches most but leaves...
I bought everything needed to put this on my new Dewalt DWS716. All I can say, is WOW! This design is unbelievable good at mitigating dust. 100%? No. But, close enough. Better than anything else I have ever seen. My old saw (I sold it so I could buy this and the InspireWoodcraft parts to put on it) spewed dust everywhere. I am actually allergic to some woods and I have asthma. So this is a fantastic solution. If you have a saw this setup fits, run, don't walk, and order all this stuff RIGHT NOW! You will be thankful.