Skip to product information
1 of 6

Inspire Woodcraft

DeWALT DWS715 Zero Clearance Dust Collection Throat Plate Gen 2

DeWALT DWS715 Zero Clearance Dust Collection Throat Plate Gen 2

Regular price $35.00 USD
Regular price Sale price $35.00 USD
Sale Sold out

Collect the dust from your miter saw that no other system can. The all-new, one-piece design of the Gen 2 Dust Collection Throat Plate has improved dust collection efficiency, installs quicker, and has a sleek new factory look, all at a significant cost reduction compared to our first-generation throat plates.

What is a Dust Collection Throat Plate?

It's a solid throat plate without an opening. Once you cut into it, you will be left with an opening that is only as wide as the blade, known as zero-clearance. This narrow opening provides material support right up to your cut line, helping prevent tear-out and keeping small offcuts from falling beneath the throat plate where they can cause dangerous ejection and kickback. Built into the underside of the throat plate is a shroud that traps all the debris that would normally be shoved down under the throat plate and forces it to exit out the rear, where it can be sucked away by your vacuum.

The Gen 2 Zero Clearance Dust Collection Throat Plate for the DeWALT DWS715 installs in less than a minute. Simply remove the six T-20 screws that hold the factory throat plate in, take out the factory plate, slide the Dust Collection Throat Plate in, and secure it reusing the factory screws.

Dust Collection Throat Plates are not intended to be used while making bevel cuts! These were designed for cabinet and furniture makers that rarely, if ever, use the bevel feature of their miter saws. Bevel cuts will destroy the shroud and the zero-clearance functionality. The full range of miter cuts can be made as long as the blade is plumb, or 90 degrees to the table.

While Dust Collection Throat Plates work well by themselves, they benefit greatly from being coupled with an upgraded aftermarket behind-the-blade collector, like this one from Shop Nation. Aftermarket upgrades like this give you a better chance of actually sucking up all the dust and debris at the source. (Inspire Woodcraft is in no way affiliated with, nor endorsed by, Shop Nation and our products are not specifically designed to work with any other manufacturer's goods unless noted.)

Only intended to be used on the DeWALT DWS715 miter saw. Not tested or guaranteed to fit any other make/model. Parts and accessories for other makes/models can be found on our website. PLEASE DOUBLE CHECK THE MODEL NUMBER OF YOUR SAW BEFORE PLACING AN ORDER. Model numbers can be found on the top side of the motor housing.

3D printed using high-quality PETG filament.

View full details

Customer Reviews

Based on 2 reviews
50%
(1)
0%
(0)
50%
(1)
0%
(0)
0%
(0)
G
Gary Zuehlke
Good product but zero clearance insert split on first use.

The product arrived promptly and in great condition. The two pieces installed effortlessly and provided great fit and fitness. The zero clearance insert however, split in half the first time time i used it. I used a sacrificial piece of wood as the instructions suggested but it still split. With the insert split, one side lifts up when cutting and negates the throat plates intention of routing dust into the pick-up chute.
I think the design and concept are very will thought out, but will need a new insert to verify.

Hi Gary!

While I have never had this happen personally, I have heard of it happening before. Unfortunately, it happens so infrequently that I don't have enough information collected to find out how to avoid it. With so many possible culprits, like type/quality of blade, how fast or slow the initial cut is made, and so on, it has been a challenge to find a fix.

At any rate, I am sending you some new inserts to get you up and running!

All the best,
Jodee

K
Kyle Law
Fits good

Would highly recommend